Whiteboard Wednesdays

This episode of Whiteboard Wednesday will review what coupling is and what you can do to combat crosstalk caused by undesirable coupling.

An overview of common uses for Copper Planes and Pours within your design including: power distribution, electromagnetic interference reduction, EMI shielding, ESD guard bands, and heat sinks.

You learned about impedance in school, but how does it relate to PCB design? This episode of Whiteboard Wednesday will discuss impedance and how to implement controlled impedance in your designs.

This episode of Whiteboard Wednesday will discuss Via Selection. This video will cover: - What is a via - The types of vias, what they are typically used for, and cost considerations - Why...

PCB Part placement is a very important part of the design process as it will drive the success of the entire project. Part Placement effects everything from manufacturing to electrical...

In our last Whiteboard Wednesday episode, Best Practices for PCB Part Placement Part 1, we reviewed the general guidelines for part placement, however there are a few other factors that need to...

You understand the importance of controlling impedance in a PCB layout, but how is it accomplished? This episode of Whiteboard Wednesdays will discuss how to measure impedance.

This episode of Whiteboard Wednesday discusses how Designing for Manufacturing (DFMA) can help you reduce any potential manufacturing pitfalls. This episode will review factors you should consider...

An overview on what factors need to be considered when choosing a part and their corresponding effect on a project.

Part one of an overview of the printed circuit board manufacturing process and information designers need to keep in mind before sending their PCB to manufacturing.

Part two of an overview of the printed circuit board manufacturing process and information designers need to keep in mind before sending their PCB to manufacturing.

You've completed your schematic design and are ready to begin the PCB layout process, but where to begin? This episode of Whiteboard Wednesdays will discuss the PCB Stackup and what factors need...

It is very important to give your manufacturer all the necessary information so your board is produced correctly, but what information does the manufacturer actually need to produce your board?...

The purpose of an assembly drawing is to show all of the components that will be assembled onto it’s two outer surfaces. The Assembly Drawing will be a guide for both the placement programmers and...

Communication and collaboration during a project are vital to ensure your design is completed on-time, on-budget and as smoothly as possible. There are many aspects to manage in a design and many...

The fabrication drawing will help the manufacturer produce your design accurately. Including the correct information in your fabrication drawing will streamline manufacturing by minimizing...