This tutorial demonstrates several different options for placing components on your PCB in OrCAD PCB Designer. After this tutorial and learn how to: Place components, review a report that identifies unplaced components, and cross probe components between Capture and PCB Editor.
To follow along, visit the blog for step-by-step instructions.
4:17
6:45Learn how to make connections between different blocks in a DDR topology and check connectivity to analyze signal integrity with Sigrity.
3:27Learn how to connect blocks in a Serial Link topology and verify connections for signal integrity analysis in Sigrity.
3:45Learn how to build a block-based serial link topology to perform signal integrity analysis with Sigrity.
3:59Learn how to create an RC circuit in PSpice to perform various SPICE simulations.
3:42Learn how to perform signal integrity analysis for a serial link system and analyze results in Sigrity.
4:03Learn how to setup analysis options for signal integrity analysis of a serial link system with Sigrity.
6:09Learn how to perform power-aware signal integrity analysis for DDR4, analyze the simulation results and generate a report with Sigrity.
6:45Learn how to configure a timing budget and simulation analysis options for power-aware DDR analysis with Sigrity.
4:29Learn how to configure the topology for a DDR device to analyze noise due to switching with Sigrity.
