This tutorial demonstrates how to create and place mechanical symbols in OrCAD PCB Designer. After this tutorial you will be able to create a mounting hole and place mechanical symbols on your PCB.
Follow the blog here for step-by-step instructions.
Most Recent Videos
4:17PSpice Simulation Tutorial: How to Ensure Proper Resolution of SPICE Simulation Results
6:45Modeling and Simulating a Power-Aware Parallel Bus System: Part 3
Learn how to make connections between different blocks in a DDR topology and check connectivity to analyze signal integrity with Sigrity.
3:27Building a Serial Link System Topology: Part 2
Learn how to connect blocks in a Serial Link topology and verify connections for signal integrity analysis in Sigrity.
3:45Building a Serial Link System Topology: Part 1
Learn how to build a block-based serial link topology to perform signal integrity analysis with Sigrity.
3:59PSpice Simulation: Creating an RC Circuit
Learn how to create an RC circuit in PSpice to perform various SPICE simulations.
3:42Simulation and Analysis of a Serial Link System: Part 2
Learn how to perform signal integrity analysis for a serial link system and analyze results in Sigrity.
4:03Simulation and Analysis of a Serial Link System: Part 1
Learn how to setup analysis options for signal integrity analysis of a serial link system with Sigrity.
6:09Circuit Simulation and Analysis of a Power-Aware Parallel Bus
Learn how to perform power-aware signal integrity analysis for DDR4, analyze the simulation results and generate a report with Sigrity.
6:45Setting Analysis Options and Timing Budget for Power-Aware Parallel Bus
Learn how to configure a timing budget and simulation analysis options for power-aware DDR analysis with Sigrity.
4:29Modeling and Simulating a Power-Aware Parallel Bus System: Part 2
Learn how to configure the topology for a DDR device to analyze noise due to switching with Sigrity.