Interactive Delay Tuning with OrCAD

July 31, 2018 Team EMA

Resolving length matching issues can be difficult and time consuming, especially on densely populated boards when space is in high-demand. However, by automating this process you can save time and focus on other aspects of the design. OrCAD Interactive Delay Tuning can help. A real-time pop up meter allows you to see when the required trace length has been achieved. Choose from sawtooth, trombone, or accordion. Select the trace and watch the meter as the delay tune is added. The meter will turn green when the desired length is met. Save time and money with Interactive Delay tuning in OrCAD PCB Designer.

Previous Article
Etch Over Void/Split Planes in OrCAD
Etch Over Void/Split Planes in OrCAD

Running traces over voids and split planes can cause impedance and noise control issues. Signal traces must...

Next Article
Net in Groups with OrCAD
Net in Groups with OrCAD

Matching trace lengths for large-bit buses and differential pairs in your design is vital. However, this ca...

OrCAD Free Trial

Try OrCAD Today