Dynamic Shape Fillets with OrCAD

July 31, 2018 Team EMA

Manually adding fillets and teardrops can add weeks to your design. And allowing a board house to add them after design completion, will leave you unaware of effects on your board. By automating this process and adhering to predefined constraint rules, you can save time and ensure your design intent is unchanged. OrCAD helps you do this with Dynamic Shape Fillets. Simply set the required parameters for the teardrops or fillets. Highlight the selection of pins or vias and OrCAD PCB Designer automatically creates the shapes. 

Previous Article
Via Array/Shielding with OrCAD
Via Array/Shielding with OrCAD

With the size of devices decreasing and frequencies increasing, the need for managing electromagnetic inter...

Next Article
Etch Over Void/Split Planes in OrCAD
Etch Over Void/Split Planes in OrCAD

Running traces over voids and split planes can cause impedance and noise control issues. Signal traces must...

OrCAD Free Trial

Try OrCAD Today